http://nyscooterclub.com/

Boring cylinder in NY?
http://nyscooterclub.com/viewtopic.php?f=5&t=19388
Page 1 of 1

Author:  pinocchio [ Thu Jan 22, 2015 10:16 am ]
Post subject:  Boring cylinder in NY?

Hey everyone,

I have a 64 Vespa 90 that I need to have the cylinder bored on. I was wondering if anyone could recommend a reputable shop (ideally around Westchester) in the NY area.

Thanks in advance!

Author:  Rob_H [ Sat Jan 24, 2015 11:36 am ]
Post subject:  Re: Boring cylinder in NY?

Give Adam a shout:

http://lambrettaengineering.com

He's lambretta-focused, but can likely do a Vespa jug.

Author:  pinocchio [ Mon Jan 26, 2015 11:59 am ]
Post subject:  Re: Boring cylinder in NY?

Thanks! I'll give him a call.

Author:  Mario [ Wed Jan 28, 2015 11:01 pm ]
Post subject:  Re: Boring cylinder in NY?

from Scooterhelp.com:

"Note: The crankcase mouth on this model was enlarged in 1966 to 61mm - an identical size as larger small frame motors like the 100 and 125 Primavera. From 1963 to 1965 the crankcase mouth is only 56mm. Larger bore kits from Malossi and Polinin can only fit on post 1966 engines without enlarging the mouth to allow the barrel spigot to fit. "

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/